Reference
Entegra EX5000 -101- 600-00108-000 Rev 07
This section describes moving data from your Zip Drive or USB Flash
Memory Drive to the EX5000.
13.1.1 Loading NavData (the Navigation Database)
Your new EX5000 will be pre-loaded with an up-to-date navigation
database. Updates to the EX5000 NavData database are available
from Jeppesen Sanderson, Inc. every 28 days and can be purchased
either individually or on a subscription basis.
!
If using a Zip Drive Dataloader:
• Allowing the portable Zip Drive to dangle by the cable can
result in damage to your MFD, or the Drive, as well as a
dataload failure.
• Do not insert the Zip disk into the Zip Drive until 5 seconds
after power-up. The disk may be damaged if it is already in
the Zip Drive when power is applied.
• After loading the CMax data into your MFD, wait until the
disk is ejected from the drive before unplugging the Drive,
or powering off the MFD. Unplugging the Zip Drive with
the disk still engaged may cause damage to the disk.
!
If using a USB Flash Memory:
• Avidyne strongly suggests that, to avoid confusion, you
reserve a USB Flash Memory Drive solely for EX5000
database transfers.
• After uploading data, do not remove the USB Flash
Memory Drive until you see and acknowledge the regular
EX5000 Startup screen.
Note: When removing the rubber cap from the data port, pull the cap
gently from the top until it pops out. Make sure the cap is all the way
out before plugging anything into the USB port.
Do not tug on the tab at the bottom of the cap; this could separate
the cap from the EX5000 bezel.
Comments to this Manuals